hikvision

Introduction

This is a very basic python module providing a basic python interface to interact with a Hikvision IP Camera

This is licensed under the MIT license.

Getting started

This module is tested against firmware 5.2.0. It may work on older versions, but that has not been tested.

For further info on the camera API's see: CGI API Guide: http://bit.ly/1RuyUuF

Development

hikvision is hosted by Github at https://github.com/fbradyirl/hikvision

CI run after commit:

tox

Install

---

git clone --recursive [e-mail]:fbradyirl/hikvision.git
cd hikvision
# NOTE: You might need administrator privileges to install python modules.
pip install -r requirements.txt
pip install -e .

Usage

Variables:

import hikvision.api

# This will use http by default (not https)
# pass False to the digest_auth parameter of CreateDevice to fallback to basic auth
# (note that basic auth and http without ssl are inherently insecure)
# more recent hikvision firmwares default to turning basic auth off
# (and that's a good idea for security)
hik_camera = hikvision.api.CreateDevice('192.168.2.5', username='admin', password='12345')
hik_camera.enable_motion_detection()
hik_camera.disable_motion_detection()
hik_camera.is_motion_detection_enabled()

• host (*Required) : This is the IP address of your Hikvision camera. Example: 192.168.1.32

• username (*Required) : Your Hikvision camera username

• password (*Required) : Your Hikvision camera username

History

2.0.3 (07-09-2020)

• Updated to use travis, tox, and some other cosmetic improvements.

2.0.4 (2020-12-08)

• Switch pipeline to Github actions