anyflow-cli-test

AnyFlow CLI

A command-line interface (CLI) for performing operations with AnyFlow.

Table of Contents

• Installation
• Usage
• First Use and Authentication
• Commands
• Configuration
• Contributing
• License

Installation

To install the anyflow-cli inside you project:

npm install anyflow-cli

Usage

After installation, you can use the anyflow cli in your terminal. To see the available commands and options, run:

anyflow help

First Use and Authentication

To get started with the AnyFlow CLI, you'll need to authenticate your session. Follow these steps:

1. Initialize Your Project: If you are starting a new project, navigate to your project directory:

   mkdir my-anyflow-project
   cd my-anyflow-project
   

2. Run the Init Command: This command will create the necessary environment variables:

   anyflow init
   

3. Run the Install Command: This will update your hardhat.config.js with the necessary configuration:

   anyflow install
   

4. Authenticate: Run the following command to authenticate your session:

   anyflow auth
   

   This command will prompt you for your API key and may attempt to open your browser. Enter your API key when prompted to complete the authentication process.

5. Verify Authentication: After successful authentication, you can verify that you are logged in by running:

   anyflow check-auth
   

   If you see a confirmation message, you are successfully authenticated and ready to use the CLI.

Commands

anyflow <command>

Available commands:

• help: Show help information for AnyFlow CLI.
• init: Create the necessary environment variables.
• install: Update your hardhat.config.js with the necessary configuration.
• auth: Authenticate your session with AnyFlow.
• check-auth: Check your authentication status.
• deploy: Upload your artifacts to the AnyFlow platform and deploy your project.

Contributing

Contributions are welcome! Please follow these steps to contribute:

1. Fork the repository.
2. Create a new branch (git checkout -b feature/YourFeature).
3. Make your changes and commit them (git commit -m 'Add some feature').
4. Push to the branch (git push origin feature/YourFeature).
5. Open a pull request.

License

This project is licensed under the ISC License - see the LICENSE file for details.